Hub-Shaft Disassembly - JLG E600 Service And Maintenance Manual

Hub-shaft Disassembly

1. Using retaining ring pliers, remove Retaining Ring
(1I) from groove in Output Shaft (1A) and discard.
EYE PROTECTION SHOULD BE WORN DURING THIS PROCEDURE.
2. Remove Thrust Washer (1H).
3. While supporting the Housing (1G) on the Output
Shaft (1A) end, press the Output Shaft (1A) out of
the Housing (1G).
NOTE: The Lip Seal (1B) may or may not be pressed out of
the Housing (1G) by the Bearing Cone (1D) during
this step.
3121813
4. Remove the Bearing Cone (1D) from the Housing
5. Invert the Housing (1G) and remove the Lip Seal
6. Using a bearing puller, remove the Bearing Cone
7. Bearing Cups (1C & 1E) will remain in Housing (1G).
NOTE: If bearing replacement is necessary, the Bearing
1A. Output Shaft 1F. Bearing Cone
1B. Lip Seal 1G. Housing
1C. Bearing Cup 1H. Thrust Washer
1D. Bearing Cone 1l. Retaining Ring
1E. Bearing Cup
Figure 3-22. Hub Shaft Disassembly
– JLG Lift –
SECTION 3 - CHASSIS & TURNTABLE
(1G).
(1B) if not already removed when Output Shaft (1A)
was pressed out of Housing (1G).
(1F) from the Output Shaft (1A).
Cups (1C & 1E) can be removed with a slide ham-
mer puller or driven out with a punch.
3-37