JLG E600 Service And Maintenance Manual page 174

SECTION 6 - JLG CONTROL SYSTEM
There is a setting that JLG strongly recommends that you
do not change. This setting is so noted below:
ELEVATION CUTBACK
CHANGING THIS SETTING MAY ADVERSELY AFFECT THE PER-
FORMANCE OF YOUR MACHINE.
ITS IS A GOOD PRACTICE TO AVOID PRESSURE-WASHING ELEC-
TRICAL/ELECTRONIC COMPONENTS. SHOULD PRESSURE-
WASHING BE UTILIZED TO WASH AREAS CONTAINING ELECTRI-
CAL/ELECTRONIC COMPONENTS, JLG INDUSTRIES INC. RECOM-
MENDS A MAXIMUM PRESSURE OF 750 PSI (52 BAR) AT A
MINIMUM DISTANCE OF 12 INCHES (30.5CM) AWAY FROM
THESE COMPONENTS. IF ELECTRICAL/ELECTRONIC COMPO-
NENTS ARE SPRAYED, SPRAYING MUST NOT BE DIRECT AND BE
FOR BRIEF TIME PERIODS TO AVOID HEAVY SATURATION.
6-8
Table 6-1. Machine Setup Descriptions
MODEL NUMBER...
TILT...
DRIVE CUTOUT...
FUNCTION CUTOUT...
JIB. . .
GROUND ALARM...
PLATFORM ALARM...
4WD ASSIST...
SOFT TOUCH
– JLG Lift –
Displays/adjusts machine model NOTE:
all personalities reset to default when
model number is altered
Displays/adjusts tilt sensor function
Displays/adjusts drive cutout switch
presence/ function
Displays/adjusts function cutout switch
presence/function
Displays/adjusts jib presence
Displays/adjusts ground alarm presence/
function
Displays/adjusts platform alarm pres-
ence/ function
Displays/adjusts 4WD assist presence
Displays/adjusts soft-touch system
presence
3121813