Carrier Disassembly - JLG E600 Service And Maintenance Manual

SECTION 3 - CHASSIS & TURNTABLE

Carrier Disassembly

1. Using a 1/4" punch, drive the Roll Pin (3G) which
holds the Planet Shaft (3E) in the Carrier (3A) down
into the Planet Shaft (3E) until it bottoms.
NOTE: Make sure that the Roll Pin has bottomed. Other-
wise, damage to the carrier could occur when the
Planet Shaft is removed.
2. Remove the Planet Shaft (3E) from the Carrier (3A).
3-38
3. Slide the Planet Gear (3F) and the two Thrust Wash-
4. Remove both rows of Needle Bearings (3C) and the
5. Using a 1/4" punch, drive the Roll Pin (3G) out of the
6. Repeat Steps 1 through 5 for the remaining two
3A. Carrier 3E. Planet Shaft
3B. Thrust Washers 3F. Planet Gear
3C. Needle Bearings 3G. Roll Pin
3D. Spacer
Figure 3-23. Carrier Disassembly
– JLG Lift –
ers (3B) out of the Carrier (3A).
Spacer (3D) from the bore of the Planet Gear (3F).
Planet Shaft (3E).
Planet Gears (3F).
3121813