Input Selection; Installation Of The Settings For A Input Source - Barco BARCOVISION 8100 Owner's Manual

INPUT SELECTION

Use the numeric keys on the RCU or use the local key pad to select the corresponding
input slot.
The source settings has to be installed for each source when these sources are
displayed for the first time.

INSTALLATION OF THE SETTINGS FOR A INPUT SOURCE.

Start up the adjustment mode by press-
ing ENTER . The main menu will be
displayed.
Push the control stick key forward or
backward to highlight File service.
ENTER selects the highlighted item and
continues to the next step. EXIT returns
always to the previous step.
* Select the LOAD function to install the correct file. Only the files which can be for
this source will be shown. (See appendix A for a list of the standard available files).
File annotation :
xxxxxxxx.xxx (Sx, xxxXxxxi)
I or blanc : i = interlaced, blanc = not
interlaced
xxxXxxx : active pixel rating
Sx : source number
xxx : file extension, first character is C (for custom made files) or
S (for standard files).
The second and third character is used for a following number
(=file index)
file index for custom files : 00 to 63.
xxxxxxxx : base name, 8 characters.
The projector leaves the factory some custom files installed.
e.g.
source 1 (video) : pal.c01
source 1 (video) : ntsc.c02
9-2
SOURCE SET UP
MAIN MENU
Picture Control
System Settings
File service
Service Mode
832c
5975617 BARCOVISION 8100 150197
INPUT SELECTION
Use the numeric keys on the RCU or use the local key pad to select the corresponding
input slot.
The source settings has to be installed for each source when these sources are
displayed for the first time.
INSTALLATION OF THE SETTINGS FOR A INPUT SOURCE.
Start up the adjustment mode by press-
ing ENTER . The main menu will be
displayed.
Push the control stick key forward or
backward to highlight File service.
ENTER selects the highlighted item and
continues to the next step. EXIT returns
always to the previous step.
* Select the LOAD function to install the correct file. Only the files which can be for
this source will be shown. (See appendix A for a list of the standard available files).
File annotation :
xxxxxxxx.xxx (Sx, xxxXxxxi)
I or blanc : i = interlaced, blanc = not
interlaced
xxxXxxx : active pixel rating
Sx : source number
xxx : file extension, first character is C (for custom made files) or
S (for standard files).
The second and third character is used for a following number
(=file index)
file index for custom files : 00 to 63.
xxxxxxxx : base name, 8 characters.
The projector leaves the factory some custom files installed.
e.g.
source 1 (video) : pal.c01
source 1 (video) : ntsc.c02
9-2
SOURCE SET UP
MAIN MENU
Picture Control
System Settings
File service
Service Mode
832c
5975617 BARCOVISION 8100 150197