How To Program An Address Into The Rcu; Input Selection - Barco R9002370 Owner's Manual

How to program an address into the RCU.

To continue using the RCU, it is necessary to enter the address shown in the 'Text Box' with the digit keys on the RCU.
For example, if the displayed address is ' 003 '. press 3 on the RCU.

Input selection.

Two possible ways of selecting an input :
a. With the digit keys on the RCU.
b. with the local keypad.
Press first the ADJUST key to display the GENERAL ACCESS menu.
Use the control keys to highlight
Press ENTER to confirm your selection.
When a a valid and connected source is selected, information about that source will be displayed in a 'Text Box' on the screen.
This information includes :
- Source Number.
- Horizontal scan rate
- Vertical scan rate.
When the entry is an invalid source number, a warning appears on screen
Input not available.
When a valid source number is selected, the projector will display this source or it will wait until the source becomes available.
A message Source not available will be displayed for a short time.
R5975809 BARCO CINE 6 ___________________________________________________________________________________
Source No Projector
1 Comp. Video
2 S-Video*
3 RGB/15K/32K
4 HDTV(Gs)
Muse
5 YUV
6 YUV on HDTV
* Input signal Y/C (luma/chroma)
On RGB/YUV/Gs/H,V sep /Gs /CS on both Pol accepted
the desired number.
input Press digit
1
2
3
4
5
6
Controlling
Source 2
Fh = 31.5 khz
Fv = 60 hz
Warning
Input not
available
Warning
source not
available
4-3