Barco BARCOVISION 8100 Owner's Manual page 36

LOCATION AND FUNCTIONS OF CONTROLS
A ddress key (sunk key), to enter the address of the projector (between 0 and
3
9). Press the sunk key with a pencil, followed by pressing one digit button
between 0 and 9.
STBY : stand by button : - to start projection when the power switch is
4
PAUSE : to stop projection for a short time, press 'PAUSE'. The image
5
disappears but full power is retained for immediate restarting.
Digit buttons : direct input selection.
6
Picture controls : use these buttons to obtain the desired picture analog
7
level (see also 'Controlling').
PHASE : to adjust the instability of the image.
8
TEXT : when adjusting one of the image, e.g. controls during a meeting, the
9
displayed bar scale can be removed by pressing 'TEXT' key first. To re-
display the bar scale on the screen, press 'TEXT' key again. 'TEXT' key only
active in operational mode.
10 FREEZ : to stop the image projection on the actual projected image.
11 ENTER : to start up the adjustment mode or to confirm an adjustment or
selection in the adjustment mode.
EXIT : to leave the adjustment mode or to scroll upwards when in the
12
adjustment mode.
Control stick key : to make menu selections when in the adjustment mode.
13
The control stick can move forward, backward, to the right or to the left.
Comparision between control stick movement and the use of the arrow keys
on the local keypad :
RCU
control stick forward
control stick backward =
control stick to the right =
control stick to the left
RC operating indication : lights up when a button on the remote control is
14
pressed. (This is a visual indicator to check the operation of the remote
control)
5-6
switched on.
- to switch off the projector without switching off the
power switch.
= local keypad
= arrow key up
arrow key down
right arrow key
= left arrow key
5975617 BARCOVISION 8100 150197
LOCATION AND FUNCTIONS OF CONTROLS
A ddress key (sunk key), to enter the address of the projector (between 0 and
3
9). Press the sunk key with a pencil, followed by pressing one digit button
between 0 and 9.
STBY : stand by button : - to start projection when the power switch is
4
PAUSE : to stop projection for a short time, press 'PAUSE'. The image
5
disappears but full power is retained for immediate restarting.
Digit buttons : direct input selection.
6
Picture controls : use these buttons to obtain the desired picture analog
7
level (see also 'Controlling').
PHASE : to adjust the instability of the image.
8
TEXT : when adjusting one of the image, e.g. controls during a meeting, the
9
displayed bar scale can be removed by pressing 'TEXT' key first. To re-
display the bar scale on the screen, press 'TEXT' key again. 'TEXT' key only
active in operational mode.
10 FREEZ : to stop the image projection on the actual projected image.
11 ENTER : to start up the adjustment mode or to confirm an adjustment or
selection in the adjustment mode.
EXIT : to leave the adjustment mode or to scroll upwards when in the
12
adjustment mode.
Control stick key : to make menu selections when in the adjustment mode.
13
The control stick can move forward, backward, to the right or to the left.
Comparision between control stick movement and the use of the arrow keys
on the local keypad :
RCU
control stick forward
control stick backward
control stick to the right =
control stick to the left
RC operating indication : lights up when a button on the remote control is
14
pressed. (This is a visual indicator to check the operation of the remote
control)
5-6
switched on.
- to switch off the projector without switching off the
power switch.
= local keypad
= arrow key up
= arrow key down
right arrow key
= left arrow key
5975617 BARCOVISION 8100 150197