Unpacking - Barco BARCOVISION 8100 Owner's Manual

UNPACKING

To open the banding, pull on the clip as shown in the first drawing.
Take the projector out of its shipping carton and place it on a table.
For transportation, the projector is mounted on a wooden board with 3 bolts. Use a
13 mm wrench to remove these bolts.
When using the projector as a table mounted configuration, always mount the 3
supporting feet by turning in into the provided holes (see drawing on next page).
Save the original shipping carton and packing material, they will come in handy if you
ever have to ship your projector. For maximum protection, repack your projector as
it was originally packed at the factory.
Contents of the shipped box :
- 1 BARCOVISION 8100
- 1 remote control unit RCU + 9V battery.
- 1 power cable with outlet plug type CEE7 or ANSI 73.11.
- 1 owner's manual
- 3 supporting feet
2-2
UNPACKING & DIMENSIONS
5975617 BARCOVISION 8100 150197
UNPACKING
To open the banding, pull on the clip as shown in the first drawing.
Take the projector out of its shipping carton and place it on a table.
For transportation, the projector is mounted on a wooden board with 3 bolts. Use a
13 mm wrench to remove these bolts.
When using the projector as a table mounted configuration, always mount the 3
supporting feet by turning in into the provided holes (see drawing on next page).
Save the original shipping carton and packing material, they will come in handy if you
ever have to ship your projector. For maximum protection, repack your projector as
it was originally packed at the factory.
Contents of the shipped box :
- 1 BARCOVISION 8100
- 1 remote control unit RCU + 9V battery.
- 1 power cable with outlet plug type CEE7 or ANSI 73.11.
- 1 owner's manual
- 3 supporting feet
2-2
UNPACKING & DIMENSIONS
5975617 BARCOVISION 8100 150197