Table of Contents
Advertisement
5.1.8 Input Connections
A
CS4 has multiple input connections for all common RGB and video sources. The input can
TLAS
be selected either manually or automatically. When
by starting up the projector, it searches for an input source by scanning the inputs one by one. If
only one source is found, this source will be projected. If different sources are found, the priority is
as follows
input facilities
Video
S-Video
5-cable input
Computer
Serial digital input
IEEE 1394 (not yet active)
When a RCVDS is connected to the projector, the '
5.1.9 Set up of the input selection:
! Press
to start up the adjustment mode.
ENTER
! Press the cursor key
! Press
to display the
ENTER
! Press the cursor key
! Press
to display the
ENTER
In the Input slots menu the available input sources are marked with
! Press the cursor key
! Press
to toggle between [
ENTER
! Press
several times to leave the adjustment mode.
EXIT
Use of a RCVDS05 or VS05 :
When using a RCVDS05, it is recommended to use a 5-cable output module in the
RCVDS. The outputs of this module have to be connected to the 5 cable input
(slot 1) of the projector.
To switch the projector in the 5-cable mode see chapter
R5976255 A
CS4 (2001-03)
TLAS
priority of automatic input selection
1
2
3
4
never automatically selected
never automatically selected
or
to select
up
down
'Installation'
Installation menu
or
to select
up
down
'Input Slots'
Input slots menu
or
to select
up
down
'Input Slots'
] or [
Manual
is selected in the
'automatic'
Automatic
.
.
.
.
x
.
].
Automatic
Input slots menu,
' selection is disabled.
.
9 Installation Mode
5-10
Advertisement
Table of Contents
