Switching Off - Barco BARCOVISION 8100 Owner's Manual

When the total run time of the lamp is 970
hours or more, the following message will
be displayed for 1 minute. This message
will be repeated every 30 minutes. Press
EXIT to remove the message before the
minute is over.
When the total run time of the lamp is 1000
hours or more, the following message, with
the exact run time is displayed on the screen.
Lamp run time is 1000 hours. Operating the
lamp longer than 1000 hours may damage
the projector. Please replace the lamp.
When OK (ENTER) is pressed to go on, the
warning will be repeated every 30 min.
The total lifetime of the lamp for a safe
operation is 1000 hours max. (normal power
mode). Do not use it longer. Replace
always with a same type of lamp. Call a
BARCO authorized service technician for
lamp replacement.
Warning : Using a lamp for more
than 1000 hours is dangerous, the lamp could explode.
Switching to stand-by.
When the projector is running and you want to go to stand-by, press the stand-by key.
Caution : Before powering down the projector, switch the projector to stand-by and let the
projector lamp cool down until the fans stop blowing (or for at least 15 minutes).

Switching off

To switch off:
- press first STANDBY key and let cool down until the fans stop blowing ( or at least 15
min).
- switch off the projector with the power switch.
6-4
POWER CONNECTION
Lamp run time
980 h
WARNING
Lamp run time is 1005 hours
Operating the lamp longer
than 1000 hours may damage
the projector.
Please replace the lamp
OK
5975617 BARCOVISION 8100 150197
When the total run time of the lamp is 970
hours or more, the following message will
be displayed for 1 minute. This message
will be repeated every 30 minutes. Press
EXIT to remove the message before the
minute is over.
When the total run time of the lamp is 1000
hours or more, the following message, with
the exact run time is displayed on the screen.
Lamp run time is 1000 hours. Operating the
lamp longer than 1000 hours may damage
the projector. Please replace the lamp.
When OK (ENTER) is pressed to go on, the
warning will be repeated every 30 min.
The total lifetime of the lamp for a safe
operation is 1000 hours max. (normal power
mode). Do not use it longer. Replace
always with a same type of lamp. Call a
BARCO authorized service technician for
lamp replacement.
Warning : Using a lamp for more
than 1000 hours is dangerous, the lamp could explode.
Switching to stand-by.
When the projector is running and you want to go to stand-by, press the stand-by key.
Caution : Before powering down the projector, switch the projector to stand-by and let the
projector lamp cool down until the fans stop blowing (or for at least 15 minutes).
Switching off
To switch off:
- press first STANDBY key and let cool down until the fans stop blowing ( or at least 15
min).
- switch off the projector with the power switch.
6-4
POWER CONNECTION
Lamp run time
980 h
WARNING
Lamp run time is 1005 hours
Operating the lamp longer
than 1000 hours may damage
the projector.
Please replace the lamp
OK
5975617 BARCOVISION 8100 150197