Barco BARCOVISION 8100 Owner's Manual page 65

CONTROLLING
- type of projector : BARCOVISION
8100
- software version
- Address : to change the address of
the projector, see Projector Address
above in this chapter.
- Installation : possible installations :
* Front/Ceiling
* Front/Table
* Rear/Ceiling
* Rear/Table
To change the installation configuration follow the instructions in chapter Installation
Set Up.
- Baud rate : transfer speed for communication with a IBM PC (or compatible) or MAC.
The baud rate of the projector must be the same as the baud rate of the connected
computer. When there is a difference, consult Set up of the baud rate for commu-
nication with a computer in chapter Connections.
- Projector Run Time : gives the total run time since the first start up. All projectors
leave the factory with a run time of approximately 24 hours.
- lamp run time : the total time the lamp has been used since it was installed
in the projector.
Attention : the total lifetime of the lamp for a safe operation is 1000 hours maximum.
Do not use it longer. Always replace the lamp with an original calibrated BARCO
lamp.
- Projector Serial number : indicates the fabrication number of the projector. This
number can be useful when calling for technical assistance.
- Lamp Serial number : indicates the fabrication number of the lamp. This number
can be useful when calling for technical assistance.
5975617 BARCOVISION 8100 150197
SUMMARY
Type : BARCOVISION 8100
Soft version : 2.13
Address : 1
Installation : front/ table
•
Baudrate : 9600
Projector run time : 104 h
Lamp run Time : 104 h
Projector Serial Number : 1012123
Lamp Serial Number : 0111111
867a
8-9
CONTROLLING
- type of projector : BARCOVISION
8100
- software version
- Address : to change the address of
the projector, see Projector Address
above in this chapter.
- Installation : possible installations :
* Front/Ceiling
* Front/Table
* Rear/Ceiling
* Rear/Table
To change the installation configuration follow the instructions in chapter Installation
Set Up.
- Baud rate : transfer speed for communication with a IBM PC (or compatible) or MAC.
The baud rate of the projector must be the same as the baud rate of the connected
computer. When there is a difference, consult Set up of the baud rate for commu-
nication with a computer in chapter Connections.
- Projector Run Time : gives the total run time since the first start up. All projectors
leave the factory with a run time of approximately 24 hours.
- lamp run time : the total time the lamp has been used since it was installed
in the projector.
Attention : the total lifetime of the lamp for a safe operation is 1000 hours maximum.
Do not use it longer. Always replace the lamp with an original calibrated BARCO
lamp.
- Projector Serial number : indicates the fabrication number of the projector. This
number can be useful when calling for technical assistance.
- Lamp Serial number : indicates the fabrication number of the lamp. This number
can be useful when calling for technical assistance.
5975617 BARCOVISION 8100 150197
SUMMARY
Type : BARCOVISION 8100
Soft version : 2.13
Address : 1
Installation : front/ table
•
Baudrate : 9600
Projector run time : 104 h
Lamp run Time : 104 h
Projector Serial Number : 1012123
Lamp Serial Number : 0111111
867a
8-9