Battery Installation In The Rcu - Barco BARCOVISION 8100 Owner's Manual

BATTERY INSTALLATION IN THE RCU.

A battery (not yet installed to save the battery life time) is delivered
inside the plastic bag with the power cord. Before using the RCU,
start first the battery installation procedure.
Remove the battery cover on the backside of the remote control by
pushing the indicated handle a little to the bottom of the RCU. Lift
up the top side of the cover at the same time (fig. 1).
Insert the new 9 V battery (type E-block or equivalent) in the lower
compartment and connect the battery to the contact plate.
Insert the battery into the lower compartment and put the cover
back.
Note : projector address has to be programmed on the RCU before
using the RCU (see chapter 'Controlling').
Contact
plate
Battery
2-4
UNPACKING & DIMENSIONS
fig.1
Insert here the 'Insert card
RCU' which you can cut out
on last page of this manual.
fig.2
310a.DRW
5975617 BARCOVISION 8100 150197
BATTERY INSTALLATION IN THE RCU.
A battery (not yet installed to save the battery life time) is delivered
inside the plastic bag with the power cord. Before using the RCU,
start first the battery installation procedure.
Remove the battery cover on the backside of the remote control by
pushing the indicated handle a little to the bottom of the RCU. Lift
up the top side of the cover at the same time (fig. 1).
Insert the new 9 V battery (type E-block or equivalent) in the lower
compartment and connect the battery to the contact plate.
Insert the battery into the lower compartment and put the cover
back.
Note : projector address has to be programmed on the RCU before
using the RCU (see chapter 'Controlling').
Contact
plate
Battery
2-4
UNPACKING & DIMENSIONS
fig.1
Insert here the 'Insert card
RCU' which you can cut out
on last page of this manual.
fig.2
310a.DRW
5975617 BARCOVISION 8100 150197