To Exit Oil Level Sense Mode; Fluid And Internal Filters Change Interval - Monaco DIPLOMAT 2004 Owner's Manual

DIPLOMAT 2004
TRANSMISSION
LUBRICATING FLUID
070176
10 • 408

To Exit Oil Level Sense Mode:

• Press Neutral, Reverse or Drive.
NOTE: Reading between the Oil Level Sensor and the
dipstick may not agree because the OLS compensates for fluid
temperatures.
NOTE: To correctly check the transmission fluid level using the
dipstick, the transmission fluid must be at operating temperature.
The oil level sensor method of checking the fluid level compensates
for transmission fluid temperature between 60º C - 104º C
(140º F - 220º F). Any temperature below 60º C (140º F), or above
104º C (220º F), will result in an error code.
Transmission performance, reliability and durability are
dependent on the type of lubricating fluids used. From the
factory, the transmission has been filled with TranSynd
synthetic transmission fluid. TranSynd
transmission fluid extends the service intervals. A small tag has
been attached to the dipstick identifying that the
transmission is filled with TranSynd
transmission fluid. The dipstick/oil fill is located in the rear
curbside engine service compartment.

Fluid and Internal Filters Change Interval:

Fluid and internal filters may require changing earlier
depending on the severity of operating conditions. Fluid must
also be changed whenever there is evidence of dirt or high
temperature operation as indicated by discoloration, strong
odor or fluid analysis. Local conditions, severity of operation
or duty cycle will dictate more or less frequent service
intervals.
NOTE: Refer to the Allison transmission
owner's manual or contact an authorized
Allison service center for change intervals.
CHASSIS INFORMATION
TM
TM
synthetic
TM
synthetic