Stepwell Cover; Entry Door; To Operate The Stepwell Cover; Adjusting The Entry Door Latch - Monaco DIPLOMAT 2004 Owner's Manual

DIPLOMAT 2004

STEPWELL COVER

ENTRY DOOR

5 • 202
The stepwell cover operates by 12 Volt DC house power.

To Operate the Stepwell Cover:

1. Turn on the battery cut-off switch.
2. Press the Step Cover switch to the desired direction. Release the
switch to stop movement.
CAUTION: When operating the stepwell cover, be sure there are
no pets, shoes or other obstructions in the stepwell area. Do not
operate the stepwell cover while standing in the stepwell area.
The entry door is adjusted at the factory and tested for all operations. The
door incorporates three separate seals to eliminate wind noise during travel.
The door uses two separate locks for safety and security. One locking system
is the door handle and the other is a dead bolt. The door handle
incorporates a primary and secondary latching system. This is used to ensure
secure and safe latching. There are adjustments which can be made to help
maintain entry door performance.

Adjusting the Entry Door Latch:

• Determine which bolt needs adjustment.
• Slowly close the entry door observing the latch and strike bolt
alignment. Do not attempt to latch if the alignment is off. If the
alignment is correct, allow the latch to catch in the first
(primary) position only.
• The latch should move to the second position with only slight
pressure applied to the entry door. Upper and lower latches should
be evenly timed. Press on the entry door to check for further
movement of the door.
• The entry handle should operate with little effort to open the
entry door. Excessive pressure indicates the bolts are set too far
back.
EQUIPMENT