Mirror Adjusting; Mirror Removal; Mirror Installation - Monaco DIPLOMAT 2004 Owner's Manual

DIPLOMAT 2004
080378
2 • 40
NOTE: Use the mirror adjust switch located on the road side
console to fine tune the view.

Mirror Removal:

• Tools needed: #3 Phillips screw driver, or a #2 Square tip.
• Remove the screw covers carefully.
• Have someone assist in holding the mirror steady. Unscrew the
four screws.
• Unplug the 12-wire plug and the 3-wire plug by using the tabs
located on the side.

Mirror Installation:

• Place the gasket on the back side of the mirror, run the plugs and
wires through the hole in the gasket.
• Align index terminals and push plugs together until locking
tabs engage.
• While holding the mirror steady, line up the holes.
• Install the screws and screw covers.

Mirror Adjusting:

• Tools needed: Allen wrench.
• Adjust the driver's seat to the travel
position.
• Using an "Allen wrench" have the
assistant loosen the two 3/16"
Allen set screws located at the
base of the mirror. (See point "A"
on the drawing.)
• Adjust the mirror so that there is a
clear side view of the coach.
• Tighten the two base screws once
the proper adjustments are made.
• To adjust the "head" of the mirror,
loosen the screw located above the
turn signal shown on point "B".
Now adjust the head of the mirror
to the left or right.
• Make sure all Allen set screws are
tight.
070181 modified
DRIVING & SAFETY