Abs Warning Lights; Abs Diagnostic Button - Monaco DIPLOMAT 2004 Owner's Manual

ABS Warning Lights:

The ABS will perform a dash indicator lamp check and self-diagnostic test
each time the ignition is switched to the on position.
• When the ignition is turned on, the ABS indicator illuminates
momentarily (2.2 seconds), verifying the self-diagnostic test. If the
ABS light illuminates while the motorhome is being operated, there
is a fault in the anti-lock brake system on the drive axle or steer
axle. This fault will not affect normal service braking. The
motorhome will need to go to a service center to repair the problem.

ABS Diagnostic Button:

By properly actuating the test button on the ABS diagnostic
center, system configuration codes and fault codes can be
retrieved as blinked sequences on the fault lamp. System
configuration codes are sequences of four blinked digits while
fault codes are sequences of two blinked digits. Refer to an
authorized Eaton/Roadranger for a list of blink code sequences.
If the test button is not pressed correctly for a specific readout,
stop and start over at the beginning of the procedure. All blink
codes are displayed by the ABS warning light only. The ATC
light does not display blink codes.
NOTE: All blink codes are
displayed by the ABS warning
light only. The ATC light does
not display blink codes.
NOTE: Contact a certified
Eaton service repair center at
(800-826-4357) for more
information.
1. Write down system configuration
codes and fault codes.
2. If the system configuration is correct,
clear the fault codes. The process for
clearing the fault codes and
reconfiguring the ECU is the same
when using the diagnostic button.
3. After clearing fault codes, retrieve the
fault codes once again to make sure
inactive fault codes were cleared.
Only active codes will now be
displayed.
CHASSIS INFORMATION
DIPLOMAT 2004
Located in the Front Electrical Panel.
Located Roadside at LP-Tank
080428
090271
10 • 377