Battery Charging; Remote Panel; Led Indications When Inverting; Led Indications When In Set-Up Mode - Monaco DIPLOMAT 2004 Owner's Manual

DIPLOMAT 2004

Battery Charging

Remote Panel

8 •304
The inverter will automatically begin charging when AC power is
supplied from shore service or the generator. The charger uses a three-stage
cycle to charge the batteries. If desired the charger may be turned off.
To turn the charger OFF or back ON:
• Press the switch marked "CHARGE" on the remote panel.
INFORMATION: Complete detailed instructions and
guidance can be found in the Owner's Information File Box. Please
refer to the information booklet provided from the manufacturer.
The remote panel monitors the inverter status and is used to change
variable settings. The panel uses LED lights to monitor values when hooked
to shore power, inverting or in the set-up mode.
LED indications when hooked to Shore Power:
• DC Volts represents DC output voltage at the inverter.
• DC Amps represents the amount of DC charge current.

LED indications when Inverting:

• DC Volts represents DC battery voltage at the inverter.
• DC Amps represents the amount of DC discharge current.

LED indications when in Set-up Mode:

(Press and hold SET-UP for five seconds):
• DC Volts represents the amount of Amp Hours of the battery bank.
• DC Amps represents the amount of load (measured in watts) needed to
activate the inverter.
• Incoming AC Breaker Amps represent battery type and operating temper-
ature.
ELECTRICAL SYSTEMS - HOUSE
060169