To Conduct The Test Procedure - Monaco DIPLOMAT 2004 Owner's Manual

DIPLOMAT 2004
4 •192

To Conduct the Test Procedure:

1. Set the selector knob to Reset.
2. Set the Dry Timer knob to 30 minutes. Push the On/Off button
to On. Wait five seconds. The Auto Dry light should be on and
the Status light flashes fast then slow.
3. Set the selector knob to a wash cycle. Set Wash Temp knob to
Warm. Water should be flowing into washer and drum should
rotate both directions.
4. Set the selector knob to Reset. Wait five seconds.
5. Set the selector knob to Spin. Water should drain and drum
rotation should speed up.
6. Set the selector knob to Reset. Wait five seconds.
7. Set the selector knob to Dry. Dryer fan should begin and drum
should rotate both directions.
8. Set the selector knob to Reset. Wait five seconds.
9. Set the Dry Time knob to zero. The Auto Dry light should go
off.
10. The door will unlock in two minutes or less. The Status light flashes fast
then slow. The door should now open.
11. Push the On/Off button to Out (Off) position. The Status light should
be off.
WARNING: Do not wash or dry articles that have previously been
cleaned, washed, soaked or spotted with gasoline, dry cleaning
solvents or other flammable or explosive substances. They give off
vapors that could ignite or explode. Do not add gasoline, dry cleaning
solvents or other flammable or explosive substances to the wash
water. Do not use heat to dry articles containing foam rubber or
similar textured, rubber-like materials.
APPLIANCES
031017