Lubrication; If The Step Fails To Operate - Monaco DIPLOMAT 2004 Owner's Manual

DIPLOMAT 2004

Lubrication

5 • 200

If the step fails to operate:

• Verify that the step switch is ON.
• Check the main power supply for the step, a 25 Amp fuse is
located in the front distribution panel.
• A magnetic door jam switch is used to control step operation.
Use a separate magnet to apply a "trigger" to the door jam
switch. Rotate test magnet to align polarity field.
WARNING: If the motorhome is driven with the step in the
extended position there is the possibility of causing major
damage to both the step and the motorhome.
Lubrication maintenance is essential to keep the step operating smoothly
and reliably. Thoroughly clean the step before performing lube maintenance.
This may require using a stiff nylon bristle-brush and automotive detergent.
Allow the step to thoroughly dry. Use Kwik Lube Spray Lubricant or
equivalent every 30 days on all pivot points, rotating linkages and slide
mechanisms.
CAUTION: Keep fingers, clothing and other hardware away from
moving components.
• Apply lubricant to all points in illustration.
• Operate the step several times to allow lubricant to penetrate surfaces.
Repeat lubricant application.
• Extend step and clean excess lubricant to reduce road grime
accumulation.
NOTE: Clean and lubricate step more frequently in adverse
weather conditions. Mud, snow, road salts and sand quickly break
down lubricants and corrodes painted surfaces.
NOTE: Silicone lubricants and WD-40 are not recommended as
they evaporate and are not weather resistant. Moving components
are then susceptible to the elements.
EQUIPMENT