System Tests - Tait TB8100 User Manual

System Tests

Self-Tests
148 Part H: Diagnosing
The Service Kit can initiate self-tests on the base station you are logged on to
and verify that the control panel controls are working.
In the Self Tests form (Diagnose > System > Self Tests), you can ask the base
station to carry out a set of self-tests. The base station itself determines whether
it passes a test. The form displays the result of those tests.
You can use the option buttons to configure the display to show all test results,
only tests that failed, or only tests that passed.
To run base station self-tests
1. Click Run Tests. The tests can take up to 90 seconds. When the tests are
completed, the Self Tests form displays the results.
2. If the base station fails a test, click Reset Base Station (Administrator access
level required). This may enable the base station to recover. You need to
connect the Service Kit again and log on to the base station.
3. Click Run Tests again. If the base station still does not pass the tests, note
any failure codes displayed in the Code column and send the base station for
repair.
MB8100-00-00-806 © TEL 2003