Editing A Channel Profile - Tait TB8100 User Manual

Service kit
Hide thumbs Also See for TB8100:
Table of Contents

Advertisement

Editing a Channel Profile

TB8100 Service Kit User's Manual
To configure power saving
1. Open the Add or Edit Channel Profile dialog box for the profile whose
power saving you want to configure.
2. Select the Power Saving tab.
3. For each power saving mode, follow these steps:
a. Select the check box to enable the mode (Sleep and Deep Sleep only).
b. In the Rx cycling box, select a time from the drop-down list. This spec-
ifies how long the receiver is turned off before being turned on again. If
you select 'off', there is no receiver power saving in this mode.
c. In the Tx keyup time box, select a time from the drop-down list. This
specifies the amount of time that the transmitter will need to key up. The
longer the time, the more circuitry can be switched off. (In Sleep and
Deep Sleep modes, the Tx keyup time is fixed.)
d. In the Start after box, specify a length of time. When the base station
has been idle for this length of time, it switches from Normal to Sleep
mode, or from Sleep to Deep Sleep mode. 'Idle' means not operating as
a talk through repeater or line-connected base station. A base station still
counts as idle, even if it makes scheduled CWID transmissions or trans-
missions using the front panel microphone.
Tip:
Use the Task Manager action Disable Power Saving to disable
power saving when it is not needed.
For example:
IF Battery voltage low THEN Enable power saving
IF NOT Battery voltage low THEN Disable power saving
The Edit Channel Profile dialog box lets you view the details of the selected
channel profile and modify them.
Next Profile and Previous Profile let you move from one profile to another
without leaving the dialog box.
Important:
If you have made changes to the current profile, click
OK to confirm them before moving to another profile.
Some items in the Default channel profile display 'See channel
table.' You specify them individually for each channel in the channel table
(Configure > Base Station > Channel Table).
Working with Channel Profiles 95

Advertisement

Table of Contents
loading

Table of Contents