Task Manager - Tait TB8100 User Manual

Automatic CWID
system
Transmit every
Wait until Tx tail
before CWID
transmission
Words per minute
Tone frequency
Message
106 Part F: Configuring Channels
The Automatic CWID system area lets you enable and configure the regular
sending of identity broadcasts. The Morse area defines what the base station
broadcasts.
Enables the automatic sending of a base station identifier. Currently the only
option is to use Morse code.
Transmission Interval
In the Add or Edit Channel Profile dialog box, CWID System tab, the
Transmission interval area lets you specify when the station ID is transmitted.
Specifies the interval in minutes between one identity broadcast and the next.
Determines what happens if the base station is transmitting when a CWID burst
is due.
If the check box is selected, the base station delays the CWID burst until the
transmit tail. Any tail timers start to count down immediately after the CWID
burst.
If the check box is cleared, the station ID is transmitted as soon as the
transmission interval after the previous transmission has elapsed. This may
interrupt speech or signalling. Any other modulating signal is temporarily
suppressed to prevent interference with the Morse code.
Tip: Use the Task Manager action Transmit CWID now to set up
identity broadcasts in ways that the Transmission interval area does
not permit.
Morse
In the Add or Edit Channel Profile dialog box, CWID System tab, the Morse
area lets you specify a unique ID for the base station. The speed of transmission
and the tone used can also be configured, but you should not need to alter the
default settings.
Specifies the speed of Morse code transmission. The 5-letter word PARIS is
used to establish the number of words per minute. This word corresponds to
50 dots.
The frequency of the tone used to transmit the Morse code.
Enter into this box up to 30 characters to be transmitted as the station ID. You
can enter any character or digit that the international morse code alphabet
supports (A-Z, 0-9, and punctuation marks). These characters will be
transmitted using the International Morse Code convention. You can also enter
spaces. They result in a silence equivalent in duration to seven dots.

Task Manager

In the Add or Edit Channel Profile dialog box, the Task Manager tab opens a
Task Manager form and displays the tasks that apply to the selected channel
profile. Use it to edit or add Task Manager inputs and actions that apply to the
channel profile.
MB8100-00-00-806 © TEL 2003