Tait TB8100 User Manual page 212

Transmitter
Talk through
repeater
Line connected
base
Power save
Over the air alarm
Over the line
alarm
Email service
CWID
Subaudible
encode
Subaudible
decode
202 Part I: Task Manager
When the Transmitter flag is enabled, the transmitter is able to transmit as usual,
according to the current channel configuration. When the flag is disabled, the
transmitter is unable to transmit signal at all.
When the Talk through repeater flag is enabled, the base station feeds received
audio into the transmitter according to the current channel profile. (Edit
Channel Profile form: Audio Path tab. The Talk-through repeater box
specifies the audio path.) When the flag is disabled, the transmitter is not given
audio from the receiver.
When the Line connected base flag is enabled, the base station feeds line in
audio into the transmitter according to the current channel profile. (Edit
Channel Profile form: Audio Path tab. The Tx audio path A or Tx audio
path A check box must be selected.) When the flag is disabled, the transmitter
is not given line in audio.
When the Power save flag is enabled, the base station applies power saving
according to the current channel profile (Edit Channel Profile form: General
tab). When the flag is disabled, power saving is not applied.
When the Over the air alarm flag is enabled, an alarm is sent over the air
according to the configuration in Configure > Alarms > Notification Methods:
Over the air notification area. When the flag is disabled, the over the air alarm
is turned off.
When the Over the line alarm flag is enabled, an alarm is sent over the line
according to the configuration in Configure > Alarms > Notification Methods:
Over the line notification area. When the flag is disabled, the over the line alarm
is turned off.
When the Email alarms flag is enabled, any alarms are sent via email according
to the configuration in Configure > Communications > Email. When it is
disabled, alarms are not sent via email.
When the CWID flag is enabled, the base station transmits a continuous wave
ID (Morse code) according to the current channel profile (Edit Channel Profile
form: CWID System tab). When the flag is disabled, no Morse code is
transmitted.
When the Subaudible encode flag is enabled, the base station encodes audio
according to the current signalling profile (Edit Signalling Profile form:
Subaudible signalling tab). When the flag is disabled, subaudible signalling is not
added to audio.
When the Subaudible decode flag is enabled, the base station decodes any
subaudible signalling according to the current signalling profile (Edit Signalling
Profile form: Subaudible signalling tab). When the flag is disabled, subaudible
signalling is not decoded, which means that there is no receiver
subaudible signalling.
gating based on
MB8100-00-00-806 © TEL 2003