Tait TB8100 User Manual page 222

SINAD
Sleep mode
Standby mode
status message
subaudible
signalling
subtone
switching range
system flag
system interface
212 Glossary
SINAD (Signal plus Noise and Distortion) is a measure of signal
quality. It is the ratio of (signal + noise + distortion) to (noise +
distortion). A SINAD of 12 dB corresponds to a signal to noise
ratio of 4:1. The TB8100 can provide an approximate SINAD
value while in service by comparing the in-band audio against
out-of-band noise. This value should not be relied upon to make
calibrated measurements.
Sleep mode is a power saving state in which a part of the base
station is switched off, and then periodically switched on again.
Standby mode is a mode of base station operation in which active
service is suspended so that special operations can be carried out,
such as programming the base station with a new configuration.
A status message is a set of information about the base station that
can be emailed. It identifies the base station, indicates the current
operating channel, lists the status of all alarms, and gives the
current values of a number of other monitored parameters. It also
contains the alarm log.
Subaudible signalling is signalling that is at the bottom end of the
range of audible frequencies. The TB8100 base station supports
CTCSS and DCS subaudible signalling.
A subtone (subaudible signalling tone) is a CTCSS tone or a DCS
code.
The switching range is the range of frequencies (about 10 MHz)
that the equipment is tuned to operate on. This is a subset of the
equipment's frequency band.
System flags are binary indicators that are read and set by Task
Manager. Generally, they are used to disable or enable
configured base station functions.
The system interface is the set of inputs to and outputs from the
base station (excluding power and RF), provided by a board
inside the reciter. A range of different boards are available for
different applications.
MB8100-00-00-806 © TEL 2003