Tait TB8100 User Manual page 122

Encode Signal
Reminder Tone
Audio Path
Line controlled
base/mic
Talk through
repeater
112 Part F: Configuring Channels
Specifies the subtone that the base station encodes when it repeats signals with
the subtone specified in the Decode signal column.
Option
Same as received
None
[any CTCSS tone or
DCS code]
When the Reminder Tone column is set to 'Enabled', the base station includes
a reminder tone in its transmissions. You configure the reminder tone in the
Advanced tab.
By default, the Audio Path column is set to 'Enabled.' When it is set to
'Disabled,' the audio path is disabled, and the base station transmits carrier (and
a reminder tone if it is configured to do so), but no audio.
Default encode signalling
In the Add or Edit Signalling Profile dialog box, Subaudible Signalling tab, the
Default encode signalling area lets you specify the subtone to be used when
transmitting audio from line in and when repeating received signals without
subaudible signalling.
Specifies the subtone to be used when the base station transmits audio from the
balanced line input, unbalanced line input, or microphone connected to the
control panel.
Specifies the subtone to be used when the base station repeats any valid received
signal. This box is disabled and has no effect if the subtone table below specifies
any subtone and gives it the action 'Gate receiver'.
Action
Encodes the transmission with the same subtone that was
in the received signal.
Gives the transmission no subaudible signalling.
Encodes the transmission with the subtone you specify
MB8100-00-00-806 © TEL 2003