Yamaha YZF-R25 Service Manual page 75

7. Stator coil lead
8. Gear position switch lead
9. Fuel tank drain hose
10. Oil pressure switch lead
11. Coolant temperature sensor coupler
12. Front turn signal light lead (left turn signal
light)
13. Front cowling assembly bracket
14. Meter assembly lead
15. Bracket
16. Wire harness
17. Frame
18. Drive sprocket cover
19. Cylinder head
A. Route the auxiliary light lead as shown in the
illustration.
B. Position the end of the fuel tank drain hose
within the range as shown in the illustration.
C. Make sure that the end of the fuel tank
breather hose is facing rearward as shown in
the illustration.
D. Position the white paint mark on the fuel tank
breather hose at the location shown in the
illustration.
E. Insert the projection on the wire harness
holder into the hole in the front cowling
assembly bracket.
F. Fasten the meter assembly lead to the
bracket with a plastic locking tie. Face the
buckle of the plastic locking tie outward with
the end pointing downward. Cut off the
excess end of the plastic locking tie to 3 mm
(0.12 in) or less.
G. Fasten the main switch lead, left handlebar
switch lead, and right handlebar switch lead
at the white tape on each lead with a plastic
locking tie.
H. Fasten the main switch lead, left handlebar
switch lead, and right handlebar switch lead
with a plastic locking tie as shown in the
illustration. Fit the end of the plastic locking tie
into the electrical components tray.
I. The main switch lead, left handlebar switch
lead, and right handlebar switch lead may be
routed in any order.
J. The gear position switch lead, negative
battery sub-wire harness, and starter motor
lead may be routed in any order.
K. Insert the projection on the wire harness
holder into the hole in the frame.
L. Position the curved portion of the fuel tank
breather hose so that the hose is routed
forward.
M. Route the fuel tank breather hose under the
stator coil lead.
N. Route the oil pressure switch lead, gear
position switch lead, and fuel tank breather
hose between the projection on the drive
chain cover and the drive chain cover.
O. When installing the drive chain cover, be sure
not to pinch the leads.
P. Route the oil pressure switch lead and gear
position switch lead may be routed in any
order.
Q. Route the fuel tank breather hose through the
guide.
2-42
CABLE ROUTING