Yamaha YZF-R25 Service Manual page 73

7. Down tube
8. Stay
9. Engine stay
10. Frame
A. Install the fuse box onto the tab on the rear
fender.
B. Pass a plastic locking tie through the hole in
the frame, and then fasten the fuse box lead
to the frame with the tie. Face the buckle of
the plastic locking tie outward with the end
pointing downward. Cut off the excess end of
the plastic locking tie to 3 mm (0.12 in) or
less.
C. Route the rear brake light switch lead to the
front of the frame cross member.
D. Route the fuel tank drain hose between the
stay and the engine stay.
E. Fasten the rear brake light switch lead at the
white tape to the down tube with a plastic
locking tie. Make sure that the plastic locking
tie contacts the frame reinforcement. Face the
buckle of the plastic locking tie outward with
the end pointing upward. Cut off the excess
end of the plastic locking tie to 3 mm (0.12 in)
or less.
2-40
CABLE ROUTING