Table of Contents
Advertisement
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
Test harness– lean angle sensor
(6P)
90890-03209
Test harness– lean angle sensor
(6P)
YU-03209
• Positive tester probe
yellow/green (wire harness color)
• Negative tester probe
black/blue (wire harness color)
45˚
45˚
c. Set the main switch to "ON".
d. Turn the lean angle sensor to 45°.
e. Measure the lean angle sensor output volt-
age.
▲
▲▲▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
EAS30562
CHECKING THE STARTER MOTOR
OPERATION
1. Check:
• Starter motor operation
Does not operate → Perform the electric
starting system troubleshooting, starting with
step 4.
Refer to "TROUBLESHOOTING" on page
8-8.
▼
▼▼▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
a. Connect the positive battery terminal "1" and
starter motor lead "2" with a jumper lead "3".
EWA13810
WARNING
• A wire that is used as a jumper lead must
have at least the same capacity of the bat-
tery lead, otherwise the jumper lead may
burn.
• This check is likely to produce sparks,
therefore, make sure no flammable gas or
fluid is in the vicinity.
1
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
ELECTRICAL COMPONENTS
b. Check the starter motor operation.
▲
▲▲▲
▲ ▲▲▲
▲
EAS30566
CHECKING THE STATOR COIL
1. Disconnect:
• Stator coil coupler
(from the wire harness)
2. Check:
• Stator coil resistance
Out of specification → Replace the stator coil
assembly (Stator coil/Crankshaft position
sensor).
▼
▼▼▼
▼ ▼▼▼
▼
a. Connect the digital circuit tester to the stator
coil coupler as shown.
▲▲▲
• Positive tester probe
white "1"
• Negative tester probe
white "2"
• Positive tester probe
▼▼▼
white "1"
• Negative tester probe
white "3"
• Positive tester probe
white "2"
• Negative tester probe
white "3"
8-90
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
Stator coil resistance
0.216–0.324 Ω (W-W)
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
Digital circuit tester
90890-03174
Model 88 Multimeter with ta-
chometer
YU-A1927
▲ ▲▲▲
▲
▲▲▲
▼ ▼▼▼
▼
▼▼▼
Advertisement
Table of Contents
Troubleshooting
