Yamaha YZF-R25 Service Manual page 204

Recommended lubricant
Lithium-soap-based grease
2. Install:
• Lower ring nut "1"
• Rubber washer "2"
• Upper ring nut "3"
• Lock washer "4"
Refer to "CHECKING AND ADJUSTING
THE STEERING HEAD" on page 3-19.
3. Install:
• Cable guide (right) "1"
• Cable guide (left) "2"
Cable guide bolt (right)
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
Cable guide bolt (left)
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
• While holding the cable guide (right) so that the
portion "a" of the guide contacts the upper
bracket "3", tighten the cable guide bolt.
• While holding the cable guide (left) so that the
projection "b" on the guide contacts the upper
bracket "3", tighten the cable guide bolt.
• Make sure that the leads are routed properly
through the guide. Refer to "CABLE ROUT-
ING" on page 2-35.
3
a
1
3
4-73
STEERING HEAD
b
2
2
3