Yamaha YZF-R25 Service Manual page 384

Fault code No.
Item
Probable cause of malfunc-
Item
tion and check
1 Connection of intake air pres-
sure sensor coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
2 Connection of ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
3 Wire harness continuity.
4 Installed condition of throttle
body sensor assembly.
Check for looseness or pinch-
ing.
5 Defective intake air pressure
sensor.
13
Intake air pressure sensor: open or short circuit detected.
Maintenance job
Improperly connected → Con-
nect the coupler securely or re-
place the wire harness.
Improperly connected → Con-
nect the coupler securely or re-
place the wire harness.
Open or short circuit → Replace
the wire harness.
Between throttle body sensor
assembly coupler and ECU cou-
pler.
black/blue–black/blue
pink/white–pink/white
blue–blue
Check for looseness or pinch-
ing.
Improperly installed sensor →
Replace the throttle bodies.
Refer to "THROTTLE BODIES"
on page 7-6.
Execute the diagnostic mode.
(Code No. 03)
When engine is stopped:
Atmospheric pressure at the
current altitude and weather
conditions is indicated.
At sea level: Approx. 101 kPa
(757.6 mmHg, 29.8 inHg)
1000 m (3300 ft) above sea lev-
el: Approx. 90 kPa (675.1
mmHg, 26.6 inHg)
2000 m (6700 ft) above sea lev-
el: Approx. 80 kPa (600.0
mmHg, 23.6 inHg)
3000 m (9800 ft) above sea lev-
el: Approx. 70 kPa (525.0
mmHg, 20.7 inHg)
When engine is cranking: Make
sure that the indication value
changes.
The value does not change
when engine is cranking. → Re-
place the throttle bodies if de-
fective.
8-39
FUEL INJECTION SYSTEM
Confirmation of service com-
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is displayed
→ Go to item 2.
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is displayed
→ Go to item 3.
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is displayed
→ Go to item 4.
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is displayed
→ Go to item 5.
Turn the main switch to "ON".
Fault code number is not dis-
played → Service is finished.
Fault code number is displayed
→ Go to item 6.
pletion