Yamaha YZF-R25 Service Manual page 189

1
b
1
4. Connect:
• Clutch cable
TIP
Lubricate the end of the clutch cable with a thin
coat of lithium-soap-based grease.
5. Install:
• Handlebar switch (left) "1"
Handlebar switch screw (left)
1.5 Nm (0.15 m·kgf, 1.1 ft·lbf)
TIP
• Align the projection "a" on the left handlebar
switch with the hole "b" in the left handlebar.
• First, tighten the front screw, then tighten the
rear screw.
1
6. Install:
• Handlebar grip "1"
• Grip end (left) "2"
Grip end bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
a
d
a
b
▼ ▼▼▼ ▼ ▼▼▼ ▼
a. Apply a thin coat of rubber adhesive onto the
end of the left handlebar.
b. Slide the handlebar grip over the end of the
left handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
TIP
• Align the projection "a" on the grip end with the
slot "b" in the handlebar weight.
c
• While holding the grip end, tighten the grip end
bolt.
• There should be 2–5 mm (0.08–0.20 in) of
clearance "c" between the handlebar grip and
the grip end.
c
▲ ▲▲▲ ▲ ▲▲▲ ▲
7. Install:
• Front brake master cylinder "1"
• Front brake master cylinder holder "2"
TIP
• Install the brake master cylinder holder with the
"UP" mark "a" facing up.
4-58
HANDLEBARS
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
1
b
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
Front brake master cylinder hold-
er bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
▼ ▼▼▼ ▼ ▼▼▼
2
a
▲ ▲▲▲ ▲ ▲▲▲