Pim Configuration Examples - HP FlexNetwork 7500 Series Configuration Manual

Task
Display PIM routing entries.
Display RP information in the
PIM-SM domain.
Display statistics for PIM packets.

PIM configuration examples

PIM-DM configuration example
Network requirements
As shown in
•
OSPF runs on the network.
•
VOD streams are sent to receiver hosts in multicast. The receiver groups of different
organizations form stub networks, and one or more receiver hosts exist on each stub network.
•
The entire PIM domain operates in the dense mode.
•
Host A and Host C are multicast receivers on two stub networks.
•
IGMPv2 runs between Switch A and N1 and between Switch B, Switch C, and N2.
Figure 47 Network diagram
Source
10.110.5.100/24
Figure 47:
Vlan-int300 Vlan-int101
Switch D
PIM-DM
Command
display pim [ vpn-instance vpn-instance-name ] routing-table
[ group-address [ mask { mask-length | mask } ] | source-address
[ mask { mask-length | mask } ] | flags flag-value | fsm |
incoming-interface interface-type interface-number | mode
mode-type | outgoing-interface { exclude | include | match }
interface-type interface-number ] *
display pim [ vpn-instance vpn-instance-name ] rp-info
[ group-address ]
display pim statistics
Switch A
Vlan-int100
Vlan-int200
Vlan-int101
Switch B
Vlan-int200
Switch C
128
Receiver
Host A
Host B
Receiver
Host C
Host D