Troubleshooting Igmp Snooping - HP FlexNetwork 7500 Series Configuration Manual

Configure Switch D:
4.
# Enable IGMP snooping globally.
<SwitchD> system-view
[SwitchD] igmp-snooping
[SwitchD-igmp-snooping] quit
# Create VLAN 100, and assign GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 to the VLAN.
[SwitchD] vlan 100
[SwitchD-vlan100] port gigabitethernet 1/0/1 to gigabitethernet 1/0/2
# Enable IGMP snooping, and enable dropping unknown multicast data packets for VLAN 100.
[SwitchD-vlan100] igmp-snooping enable
[SwitchD-vlan100] igmp-snooping drop-unknown
[SwitchD-vlan100] quit
Verifying the configuration
# Display statistics for IGMP messages learned through IGMP snooping on Switch B.
[SwitchB] display igmp-snooping statistics
Received IGMP general queries:
Received IGMPv1 reports:
Received IGMPv2 reports:
Received IGMP leaves:
Received IGMPv2 specific queries:
Sent IGMPv2 specific queries:
Received IGMPv3 reports:
Received IGMPv3 reports with right and wrong records:
Received IGMPv3 specific queries:
Received IGMPv3 specific sg queries:
Sent IGMPv3 specific queries:
Sent IGMPv3 specific sg queries:
Received error IGMP messages:
The output shows that all switches except Switch A can receive the IGMP general queries
after Switch A acts as the IGMP snooping querier.

Troubleshooting IGMP snooping

Layer 2 multicast forwarding cannot function
Symptom
Layer 2 multicast forwarding cannot function on the Layer 2 device.
Solution
To resolve the problem:
Use the display igmp-snooping command to display IGMP snooping status.
1.
If IGMP snooping is not enabled, use the igmp-snooping command in system view to enable
2.
IGMP snooping globally. Then, use the igmp-snooping enable command in VLAN view to
enable IGMP snooping for the VLAN.
If IGMP snooping is enabled globally but not enabled for the VLAN, use the igmp-snooping
3.
enable command in VLAN view to enable IGMP snooping for the VLAN.
If the problem persists, contact Hewlett Packard Enterprise Support.
4.
3
0
12
0
0
0
0
0
0
0
0
0
37
0