Pim Configuration Examples; Pim-Dm Configuration Example - HP 6125XLG Configuration Manual

Task
Display BSR information in the
PIM-SM domain.
Display information about the
routes used by PIM.
Display C-RP information in the
PIM-SM domain.
Display PIM information on an
interface.
Display PIM neighbor information.
Display PIM routing table
information.
Display RP information in the
PIM-SM domain.

PIM configuration examples

PIM-DM configuration example

Network requirements
As shown in
different organizations form stub networks, and one or more receiver hosts exist in each stub network. The
entire PIM domain operates in the dense mode.
Host A and Host C are multicast receivers in two stub networks.
IGMPv2 runs between Switch A and N1 and between Switch B, Switch C, and N2.
Command
display pim bsr-info
display pim claimed-route [ source-address ]
display pim c-rp [ local ]
display pim interface [ interface-type interface-number ] [ verbose ]
display pim neighbor [ neighbor-address | interface interface-type
interface-number | verbose ] *
display pim routing-table [ group-address [ mask { mask-length | mask } ]
| source-address [ mask { mask-length | mask } ] | flags flag-value | fsm
| incoming-interface interface-type interface-number | mode mode-type
| outgoing-interface { exclude | include | match } interface-type
interface-number ] *
display pim rp-info [ group-address ]
Figure 32, VOD streams are sent to receiver hosts in multicast. The receiver groups of
83