Configuring Ipv6 Multicast Routing And Forwarding - HP FlexNetwork 7500 Series Configuration Manual

To enable IPv6 multicast routing:
Step
Enter system view.
1.
Enable IPv6 multicast
2.
routing and enter IPv6 MRIB
view.

Configuring IPv6 multicast routing and forwarding

Before you configure IPv6 multicast routing and forwarding, complete the following tasks:
•
Configure an IPv6 unicast routing protocol so that all devices in the domain can interoperate at
the network layer.
•
Configure IPv6 PIM-DM or IPv6 PIM-SM.
Specifying the longest prefix match principle
You can enable the device to use the longest prefix match principle for RPF route selection. For more
information about RPF route selection, see
To specify the longest prefix match principle:
Step
Enter system view.
1.
Enter IPv6 MRIB view.
2.
Specify the longest prefix
3.
match principle.
Configuring IPv6 multicast load splitting
You can enable the device to split multiple IPv6 multicast data flows on a per-source basis or on a
per-source-and-group basis.
You do not need to enable IPv6 multicast routing before this configuration.
To configure IPv6 multicast load splitting:
Step
Enter system view.
1.
Enter IPv6 MRIB view.
2.
Configure IPv6 multicast
3.
load splitting.
Command
system-view
ipv6 multicast routing
[ vpn-instance
vpn-instance-name ]
"RPF check
Command
system-view
ipv6 multicast routing
[ vpn-instance
vpn-instance-name ]
longest-match
Command
system-view
ipv6 multicast routing
[ vpn-instance
vpn-instance-name ]
load-splitting {source |
source-group }
277
Remarks
N/A
By default, IPv6 multicast routing
is disabled.
process."
Remarks
N/A
N/A
By default, the route preference
principle is used.
Remarks
N/A
N/A
By default, IPv6 multicast load
splitting is disabled.
This command does not take
effect on IPv6 BIDIR-PIM.