HP FlexNetwork 7500 Series Configuration Manual page 363

[SwitchA-Vlan-interface100] quit
# Enable IPv6 PIM-SM on the other interfaces.
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] ipv6 pim sm
[SwitchA-Vlan-interface101] quit
[SwitchA] interface vlan-interface 102
[SwitchA-Vlan-interface102] ipv6 pim sm
[SwitchA-Vlan-interface102] quit
# Enable IPv6 multicast routing, MLD, and IPv6 PIM-SM on Switch B and Switch C in the same
way Switch A is configured. (Details not shown.)
# Enable IPv6 multicast routing and IPv6 PIM-SM on Switch D and Switch E in the same way
Switch A is configured. (Details not shown.)
Configure the IPv6 SSM group range as FF3E::/64 on Switch A.
4.
[SwitchA] acl ipv6 number 2000
[SwitchA-acl6-basic-2000] rule permit source ff3e:: 64
[SwitchA-acl6-basic-2000] quit
[SwitchA] ipv6 pim
[SwitchA-pim6] ssm-policy 2000
[SwitchA-pim6] quit
Configure the IPv6 SSM group range on Switch B, Switch C, Switch D, and Switch E in the
5.
same way Switch B is configured. (Details not shown.)
Verifying the configuration
# Display IPv6 PIM information on Switch A.
[SwitchA] display ipv6 pim interface
Interface
Vlan100
Vlan101
Vlan102
# Send an MLDv2 report from Host A to join the IPv6 multicast source and group (4001::100/64,
FF3E::101). (Details not shown.)
# Display IPv6 PIM multicast routing table information on Switch A.
[SwitchA] display ipv6 pim routing-table
Total 0 (*, G) entry; 1 (S, G) entry
(4001::100, FF3E::101)
Protocol: pim-ssm, Flag:
UpTime: 00:00:11
Upstream interface: Vlan-interface101
Upstream neighbor: 1002::2
RPF prime neighbor: 1002::2
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface100
# Display IPv6 PIM multicast routing table information on Switch B.
[SwitchD] display ipv6 pim routing-table
NbrCnt HelloInt
0 30
1 30
1 30
Protocol: mld, UpTime: 00:00:11, Expires: 00:03:25
DR-Pri DR-Address
1 FE80::A01:201:1
(local)
1 FE80::A01:201:2
1 FE80::A01:201:3
353