HP FlexNetwork 7500 Series Configuration Manual page 182

Device
Switch B
Switch B
Switch B
Switch B
Configuration procedure
Assign an IP address and subnet mask to each interface according to
1.
shown.)
Configure OSPF on the switches. (Details not shown.)
2.
Enable IP multicast routing, IGMP, and PIM-SM:
3.
# On Switch B, enable IP multicast routing.
<SwitchB> system-view
[SwitchB] multicast routing
[SwitchB-mrib] quit
# Enable IGMP on the receiver-side interface (VLAN-interface 100).
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] igmp enable
[SwitchB-Vlan-interface100] quit
# Enable PIM-SM on the other interfaces.
[SwitchB] interface vlan-interface 103
[SwitchB-Vlan-interface103] pim sm
[SwitchB-Vlan-interface103] quit
[SwitchB] interface Vlan-interface 101
[SwitchB-Vlan-interface101] pim sm
[SwitchB-Vlan-interface101] quit
[SwitchB] interface loopback 0
[SwitchB-LoopBack0] pim sm
[SwitchB-LoopBack0] quit
[SwitchB] interface loopback 10
[SwitchB-LoopBack10] pim sm
[SwitchB-LoopBack10] quit
[SwitchB] interface loopback 20
[SwitchB-LoopBack20] pim sm
[SwitchB-LoopBack20] quit
# Enable IP multicast routing, IGMP, and PIM-SM on Switch A, Switch C, Switch D, and Switch
E in the same way Switch B is configured. (Details not shown.)
Configure C-BSRs and C-RPs:
4.
# Configure Loopback 10 as a C-BSR and Loopback 20 as a C-RP on Switch B.
[SwitchB] pim
[SwitchB-pim] c-bsr 3.3.3.3
[SwitchB-pim] c-rp 10.1.1.1
[SwitchB-pim] quit
# Configure a C-BSR and a C-RP on Switch D in the same way Switch B is configured. (Details
not shown.)
Configure MSDP peers:
5.
Interface IP address
Vlan-int101 192.168.1.1/24
Loop0 1.1.1.1/32
Loop10 3.3.3.3/32
Loop20 10.1.1.1/32
Device Interface
Switch D Loop10
Switch D Loop20
Switch E Vlan-int400
Switch E Vlan-int104
172
IP address
4.4.4.4/32
10.1.1.1/32
10.110.6.1/24
10.110.4.2/24
Figure 58. (Details not