Use the display acl ipv6 command to verify that the configured IPv6 ACL meets the IPv6
1.
multicast group policy requirements.
Use the display this command in MLD-snooping view or in a corresponding interface view to
2.
verify that the correct IPv6 multicast group policy has been correctly applied. If the applied IPv6
multicast group policy is not correct, use the group-policy or mld-snooping group-policy
command to apply the correct IPv6 multicast group policy.
Use the display mld-snooping command to verify that dropping unknown IPv6 multicast data
3.
is enabled. If this feature is not enabled, use the drop-unknown or mld-snooping
drop-unknown command to enable this feature.
If the problem persists, contact Hewlett Packard Enterprise Support.
4.
254