An Mvrf Cannot Be Created - HP FlexNetwork 7500 Series Configuration Manual

The same PIM mode is running on all the interfaces of the same VPN instance on different
PE devices and on all the interfaces of the P router.
Use the display ip routing-table command to verify that a unicast route exists from the VPN
4.
instance on the local PE device to the same VPN instance on each remote PE device.
Use the display bgp peer command to verify that the BGP peer connections have been
5.
correctly configured.
If the problem persists, contact Hewlett Packard Enterprise Support.
6.

An MVRF cannot be created

Symptom
A VPN instance cannot create an MVRF correctly.
Solution
Use the display pim bsr-info command to verify that the BSR information exists on the public
1.
network and the VPN instance. If it does not, verify that a unicast route exists to the BSR.
Use the display pim rp-info command to examine the RP information. If no RP information is
2.
available, verify that a unicast route exists to the RP. Use the display pim neighbor command
to verify that the PIM adjacencies have been correctly established on the public network and
the VPN.
Use the ping command to examine the connectivity between the VPN DR and the VPN RP.
3.
If the problem persists, contact Hewlett Packard Enterprise Support.
4.
226