Configuring Mld Snooping Policies - HP FlexNetwork 7500 Series Configuration Manual

Setting the 802.1p priority for MLD messages in a VLAN
Step
Enter system view.
1.
Enter VLAN view.
2.
Set the 802.1p priority for
3.
MLD messages in the
VLAN.

Configuring MLD snooping policies

Before you configure MLD snooping policies, complete the following tasks:
•
Enable MLD snooping for the VLAN.
•
Determine the ACLs used by the IPv6 multicast group policies.
•
Determine the maximum number of IPv6 multicast groups that a port can join.
Configuring an IPv6 multicast group policy
This feature enables the switch to filter MLD reports based on the used ACL that specifies the IPv6
multicast groups and the optional sources. Use this feature to control the IPv6 multicast groups that
receiver hosts can join.
Configuration restrictions and guidelines
When you configure an IPv6 multicast group policy, follow these restrictions and guidelines:
•
This configuration takes effect on the IPv6 multicast groups that ports join dynamically.
•
You can configure an IPv6 multicast group policy globally for all ports in MLD-snooping view or
for a port in interface view. For a port, the port-specific configuration takes priority over the
global configuration.
Configuring an IPv6 multicast group policy globally
Step
Enter system view.
1.
Enter MLD-snooping view.
2.
Configure an IPv6 multicast
3.
group policy globally.
Configuring an IPv6 multicast group policy on a port
Step
Enter system view.
1.
Enter Layer 2 Ethernet
2.
interface view or Layer 2
aggregate interface view.
Configure an IPv6 multicast
3.
group policy for the port.
Command
system-view
vlan vlan-id
mld-snooping dot1p-priority
priority-number
Command
system-view
mld-snooping
group-policy acl6-number [ vlan
vlan-list ]
Command
system-view
interface interface-type
interface-number
mld-snooping group-policy
acl6-number [ vlan vlan-list ]
241
Remarks
N/A
N/A
The default setting is 0.
Remarks
N/A
N/A
By default, no IPv6 multicast
group policies exist. Receiver
host can join any IPv6 multicast
groups.
Remarks
N/A
N/A
By default, no IPv6 multicast
group policies exist on a port.
Hosts attached to the port can join
any IPv6 multicast groups.