Task
Display PIM information on an
interface.
Display PIM neighbor information.
Display PIM routing table
information.
Display RP information in the
PIM-SM domain.
PIM configuration examples
PIM-DM configuration example
Network requirements
As shown in
different organizations form stub networks, and one or more receiver hosts exist in each stub network. The
entire PIM domain operates in the dense mode.
Host A and Host C are multicast receivers in two stub networks.
IGMPv2 runs between Switch A and N1 and between Switch B, Switch C, and N2.
Figure 32 Network diagram
Source
10.110.5.100/24
Device
Figure
32, VOD streams are sent to receiver hosts in multicast. The receiver groups of
Vlan-int300
Vlan-int101
Switch D
PIM-DM
Interface
IP address
Command
display pim interface [ interface-type interface-number ] [ verbose ]
display pim neighbor [ neighbor-address | interface interface-type
interface-number | verbose ] *
display pim routing-table [ group-address [ mask { mask-length | mask } ]
| source-address [ mask { mask-length | mask } ] | flags flag-value | fsm
| incoming-interface interface-type interface-number | mode mode-type
| outgoing-interface { exclude | include | match } interface-type
interface-number ] *
display pim rp-info [ group-address ]
Switch A
Vlan-int100
Vlan-int200
Vlan-int101
Switch B
Vlan-int200
Switch C
Device
83
Receiver
Host A
Host B
Receiver
Host C
Host D
Interface
IP address