Configuring Ipv6 Pim-Sm - HP FlexNetwork 7500 Series Configuration Manual

For more information about the configuration of other timers in IPv6 PIM-DM, see
common IPv6 PIM

Configuring IPv6 PIM-SM

This section describes how to configure IPv6 PIM-SM.
IPv6 PIM-SM configuration task list
Tasks at a glance
(Required.)
(Required.)
•
Configuring a static RP
•
Configuring a C-RP
Configuring a
•
(Required.)
•
(Optional.)
•
(Optional.)
(Optional.)
(Optional.)
(Optional.)
Configuration prerequisites
Before you configure IPv6 PIM-SM, configure an IPv6 unicast routing protocol so that all devices in
the domain can interoperate at the network layer.
Enabling IPv6 PIM-SM
Enable IPv6 multicast routing before configuring IPv6 PIM.
With IPv6 PIM-SM enabled on interfaces, routers can establish IPv6 PIM neighbor relationship and
process IPv6 PIM messages from their IPv6 PIM neighbors. As a best practice, enable IPv6 PIM-SM
on all non-border interfaces of routers when you deploy an IPv6 PIM-SM domain.
IMPORTANT:
All the interfaces on the same router must operate in the same IPv6 PIM mode in the public network
or the same VPN instance.
To enable IPv6 PIM-SM:
Step
Enter system view.
1.
Enable IPv6 multicast
2.
routing and enter IPv6 MRIB
view.
Return to system view.
3.
timers."
Enabling IPv6 PIM-SM
Configuring an RP:
BSR:
Configuring a C-BSR
Configuring an IPv6 PIM domain border
Disabling BSM semantic fragmentation
Configuring IPv6 multicast source registration
Configuring the switchover to SPT
Configuring common IPv6 PIM features
Command
system-view
ipv6 multicast routing
[ vpn-instance
vpn-instance-name ]
quit
318
Remarks
N/A
You must configure a static RP, a C-RP, or
both in an IPv6 PIM-SM domain.
Skip the task of configuring a BSR on an IPv6
network without C-RPs.
N/A
N/A
N/A
Remarks
N/A
By default, IPv6 multicast routing
is disabled.
N/A
"Configuring