Specifying An Mld Version - HP FlexNetwork 7500 Series Configuration Manual

Step
Enable IPv6 multicast
2.
routing and enter IPv6 MRIB
view.
Return to system view.
3.
Enter interface view.
4.
Enable MLD.
5.

Specifying an MLD version

For MLD to operate correctly, you must specify the same MLD version for all routers on the same
subnet.
To specify an MLD version:
Step
Enter system view.
1.
Enter interface view.
2.
Configure an MLD version
3.
on the interface.
Configuring a static group member
You can configure an interface as a static group member of an IPv6 multicast group. The interface
can always receive IPv6 multicast data for the group.
A static group member does not respond to MLD queries. When you complete or cancel this
configuration on an interface, the interface does not send an unsolicited MLD report or done
message. This is because the interface is not a real member of the IPv6 multicast group.
Configuration guidelines
The interface to be configured as a static group member has the following restrictions:
•
If the interface is MLD and IPv6 PIM-SM enabled, it must be an IPv6 PIM-SM DR.
•
If the interface is MLD enabled but not IPv6 PIM-SM enabled, it must be an MLD querier.
For more information about IPv6 PIM-SM and DR, see
Configuration procedure
To configure a static group member:
Step
Enter system view.
1.
Enter interface view.
2.
Configure a static group
3.
member.
Command
ipv6 multicast routing
[ vpn-instance
vpn-instance-name ]
quit
interface interface-type
interface-number
mld enable
Command
system-view
interface interface-type
interface-number
mld version version-number
"Configuring IPv6
Command
system-view
interface interface-type
interface-number
mld static-group
ipv6-group-address [ source
ipv6-source-address ]
289
Remarks
By default, IPv6 multicast routing
is disabled.
N/A
N/A
By default, MLD is disabled.
Remarks
N/A
N/A
The default setting is 1.
PIM."
Remarks
N/A
N/A
By default, the interface is not a
static group member of any IPv6
multicast groups.