Enabling Pim Nsr - HP FlexNetwork 7500 Series Configuration Manual

Step
Enter system view.
1.
Enter interface view.
2.
Enable PIM passive mode
3.
on the interface.

Enabling PIM NSR

This feature enables PIM to back up protocol state information and data, including PIM neighbor
information and routes, from the active process to the standby process. The standby process
immediately takes over when the active process fails. Use this feature to avoid route flapping and
forwarding interruption for PIM when an active/standby switchover occurs.
BIDIR-PIM does not support this feature.
To enable PIM NSR:
Step
Enter system view.
1.
Enable PIM NSR.
2.
Displaying and maintaining PIM
Execute display commands in any view and reset commands in user view.
Task
Display register-tunnel interface
information.
Display BSR information in the
PIM-SM domain.
Display information about the
routes used by PIM.
Display C-RP information in the
PIM-SM domain.
Display DF information in the
BIDIR-PIM domain.
Display PIM information on an
interface.
Display PIM neighbor information.
Command
system-view
interface interface-type
interface-number
pim passive
Command
system-view
pim non-stop-routing
Command
display interface [ register-tunnel [ interface-number ] ] [ brief
[ description | down ] ]
display pim [ vpn-instance vpn-instance-name ] bsr-info
display pim [ vpn-instance vpn-instance-name ] claimed-route
[ source-address ]
display pim [ vpn-instance vpn-instance-name ] c-rp [ local ]
display pim [ vpn-instance vpn-instance-name ] df-info
[ rp-address ]
display pim [ vpn-instance vpn-instance-name ] interface
[ interface-type interface-number ] [ verbose ]
display pim [ vpn-instance vpn-instance-name ] neighbor
[ neighbor-address | interface interface-type interface-number |
verbose ] *
127
Remarks
N/A
N/A
By default, PIM passive mode is
disabled.
Remarks
N/A
By default, PIM NSR is disabled.