HP FlexNetwork 7500 Series Configuration Manual page 139

Table 7 Interface and IP address assignment
Device
Switch A
Switch A
Switch B
Switch B
Switch C
Configuration procedure
Assign an IP address and subnet mask for each interface according to
1.
shown.)
Configure OSPF on the switches in the PIM-DM domain. (Details not shown.)
2.
Enable IP multicast routing, IGMP, and PIM-DM:
3.
# On Switch A, enable IP multicast routing.
<SwitchA> system-view
[SwitchA] multicast routing
[SwitchA-mrib] quit
# Enable IGMP on the receiver-side interface (VLAN-interface 100).
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] igmp enable
[SwitchA-Vlan-interface100] quit
# Enable PIM-DM on VLAN-interface 103.
[SwitchA] interface vlan-interface 103
[SwitchA-Vlan-interface103] pim dm
[SwitchA-Vlan-interface103] quit
# Enable IP multicast routing, IGMP, and PIM-DM on Switch B and Switch C in the same way
Switch A is configured. (Details not shown.)
# On Switch D, enable IP multicast routing, and enable PIM-DM on each interface.
<SwitchD> system-view
[SwitchD] multicast routing
[SwitchD-mrib] quit
[SwitchD] interface vlan-interface 300
[SwitchD-Vlan-interface300] pim dm
[SwitchD-Vlan-interface300] quit
[SwitchD] interface vlan-interface 103
[SwitchD-Vlan-interface103] pim dm
[SwitchD-Vlan-interface103] quit
[SwitchD] interface vlan-interface 101
[SwitchD-Vlan-interface101] pim dm
[SwitchD-Vlan-interface101] quit
[SwitchD] interface vlan-interface 102
[SwitchD-Vlan-interface102] pim dm
[SwitchD-Vlan-interface102] quit
Verifying the configuration
# Display PIM information on Switch D.
Interface IP address
Vlan-int100 10.110.1.1/24
Vlan-int103 192.168.1.1/24
Vlan-int200 10.110.2.1/24
Vlan-int101 192.168.2.1/24
Vlan-int200 10.110.2.2/24
Device Interface
Switch C Vlan-int102
Switch D Vlan-int300
Switch D Vlan-int103
Switch D Vlan-int101
Switch D Vlan-int102
129
IP address
192.168.3.1/24
10.110.5.1/24
192.168.1.2/24
192.168.2.2/24
192.168.3.2/24
Figure 47. (Details not