User Interface - Siemens Pointek CLS 200 Instruction Manual

Local Operation: Pointek CLS 200
(standalone unit)
• Local operation gives you access to all the functions listed in the table on page 46,
Quick Reference: operating functions using input keypad
• An extended range of functions is available only via remote operation using
PROFIBUS PA: see
page 76.

User Interface

You can parameterize the transmitter using the input keypad, and view measuring results,
error messages and modes of operation on the digital display.
Input keypad
Three keys M, ⇑ and ⇓, are located below the display (see
keypad
on page 44). The keys are accessible when you open the lid. The lid must be
closed again after programming.
Digital display
The digital display locally displays one
of the following:
• the measured value and associated
units
• the logical level
• the numerical value and mode
number
• an error message and status
information.
1 – Primary Reading (displays measured value, or logical level, or an error message)
2 – Auxiliary Reading (displays the Bar Graph, or Units, or Status [error code])
3 – Indicator for Write Protection / Mode number/ Simulation
4 – Down arrow indicates switch output open
5 – Negative sign
6 – Up arrow indicates switch output closed
7 – Communication Indicator - visible when communications are in progress
Page IIB–40 Pointek CLS 200 (standalone unit) – INSTRUCTION MANUAL
Remote Operation via PROFIBUS PA: Pointek CLS 200
.
on
Local operation using the
7ML19985AR02