Siemens Pointek CLS 200 Instruction Manual page 47

Local operation using the keypad
Notes:
• The HW Write Protection must be disabled for keypad operation (see
Write Protection (default: OFF, display – –)
• If HW Write protection is enabled, it is possible to read parameters, but any attempt to
make changes will be rejected (error code F_001: see
The keypad consists of three input keys below the display: ⇑, ⇓, and M. A flashing digit
indicates the position of the cursor.
decrement key/ cursor movement
Mode selection and adjustment
WARNING: It is essential to check settings during the process itself,
and confirm that they are correct, before regular operation commences.
Note:
The master reset function is available only via SIMATIC PDM
• To select a mode, press M (mode key).
To change a value in a mode, press ⇑ to increment a value, or ⇓ to decrement a
•
1
value.
To move the cursor to the right, press ⇑.
•
• To switch to the next mode, press M again. To cycle forwards though the menu,
press M repeatedly. To move backwards through the menu, hold M and tap ⇑
• To abort editing, press M while a digit is flashing, and before editing the least
significant digit.
1.
⇑ ⇑
The and keys can both be used to open the Edit function: see
ues:
on the next page.
Page IIB–44 Pointek CLS 200 (standalone unit) – INSTRUCTION MANUAL
Mode key
1
increment key
1
, on page 51).
Status codes
M
Editing numerical val-
Mode 10: HW
, on page 48).
.
7ML19985AR02