Nortel 8300 Reference Manual page 44

44 Chapter 4 SMP log error messages
Message AAAP_tacacs_task_message_handler: mutex id null
Severity ERROR
Description Error in communications with TACACS+ task
Synopsis If proceeds, must restart switch, if need to use TACACS+.
Action N/A
Message AceEntry Mode <value> is not recognizable
Severity ERROR
Description The ACE has modes for permit, deny, redirect, inactive. An unrecognized mode is
not expected from user. This could be the result of corruption or missing/
insufficient consistency check.
Synopsis N/A
Action Try removing/enabling filters on the port. Try a delete/create for the ACG from the
port. Check dump using aclDumpAclTbl() or aclDumpAceList().
Message Acg Reference Count is <value> cannot be decremented for Acl Id <value>
Severity ERROR
Description The filter module's table management keeps dependency between the ACL and
ACG in order to allow/prevent ACL modification or deletion.
Synopsis N/A
Action Check the dump using aclDumpAclTbl(). Delete all the ACGs, ACLs, and recreate
them.
Message AcgId <value> PclId <value> cannot remove Pcl <value>
Severity ERROR
Description This message indicates that filter configuration in hardware could not be cleared.
Possible reasons for this are:
A.) It is enabled on other ports
B.) It does not exist in the hardware.
Severity N/A
Action Try removing or enabling filters on the port.
316806-C