Nortel 8300 Reference Manual page 104

104 Chapter 4 SMP log error messages
Message Invalid Card Type fpr phyInit Slot <value>
Severity WARNING
Description This message indicates that an invalid card type has been detected.
Synopsis N/A
Action N/A
Message Invalid configuration: network appears in two areas
Severity INFO
Description This message is generated when the same route appears for different areas.
Synopsis Two areas have the same network.
Action Configure the network properly so there is no repetition.
Message invalid interface index
Severity ERROR
Description This message is generated when a VLAN ID is out of range. For example, if you
enable or disable IGMP for the circuit using an invalid VLAN, then this error
message occurs.
Synopsis The VLAN interface being used is invalid.
Action Provide a valid VLAN ID. Check the instructions in the VLAN configuration
command. If this error persists, then contact customer support for further
information.
Message Invalid Port <value>
Severity ERROR
Description This message indicates that port translation failed.
Synopsis N/A
Action N/A
Message invalid power supply configuration detected, PoE disabled and all PoE power
removed
Severity ERROR
Description This message indicates that mixed types of power supplies were installed in the
chassis.
Synopsis PoE function disabled.
Action Remove or replace power supplies to ensure that there are no mixed types of
power supplies installed.
316806-C