Nortel 8300 Reference Manual page 194

194 Chapter 4 SMP log error messages
Message source <src filename> and destination <dst filename>
Severity INFO
Description This message is generated when the source file is <src filename> and destination
file is <dst filename>.
Synopsis N/A
Action N/A
Message STG <value> HAS ALREADY BEEN USED
Severity INFO
Description This message is generated when the maximum number of supported STGs has
already been taken.
Synopsis STGs are exhausted.
Action Change the configuration to free STGs.
Message syncTaskAdd: failed to create <taskId>
Severity ERROR
Description This message is generated when the system fails to create the semaphore.
Synopsis N/A
Action Reboot the switch and contact the customer service team if the problem persists.
Message syncTaskAdd: taskVarAdd <value> failed,
Severity ERROR
Description This message is generated when the system fails to add a task variable.
Synopsis N/A
Action Reboot the switch and contact the customer service team if the problem persists.
Message syncTaskAdd: taskVarSet <value> <value> semId <value>
Severity ERROR
Description This message is generated when the system fails to set the task variable semId.
Synopsis N/A
Action Reboot the switch and contact the customer service team if the problem persists.
316806-C