Nortel 8300 Reference Manual page 184

184 Chapter 4 SMP log error messages
Message rcIpTask: Can't take semaphore
Severity FATAL
Description This message is generated when the semaphore was not available.
Synopsis Semaphore unavailable.
Action Contact customer service and have the following information available for further
analysis: system logs including any memory dumps, switch configuration, and
network topology.
Message rcIpVlanSetIpAddress: chAssignMacAddrVlan failed for IfIndex <value>!
MacOffset <value>
Severity FATAL
Description This message is generated if the system is not able to allocate a Mac Address for
the VLAN. This is a fatal error.
Synopsis Unable to assign Mac Address.
Action Contact customer service and have the following information available for further
analysis: system logs including any memory dumps, switch configuration and
network topology.
Message rcIpVlanSetIpAddress: chGetMacAddrVlan failed for IfIndex%d! \nNo mac
address available
Severity WARNING
Description This message is generated if the available pool of MAC Addresses is exhausted.
Synopsis Unable to assign Mac Address for a VLAN.
Action This is a software error. Contact customer service for further troubleshooting.
Message rcIpVlanSetIpAddress: ipCircAddIPA failed for <value> on IfIndex <value>
Severity FATAL
Description This message is generated when an invalid IP record is encountered. Thus, the
circuit is not set.
Synopsis Invalid IP record.
Action Contact customer service and have the following information available for further
analysis: system logs including any memory dumps, switch configuration, and
network topology.
316806-C